|
Composition:
100% wowen fiberglass ; lightly
coated at factory to reduce fiber separation and provide an efficient
surface for painting.
Width:
100 cm (39 inches).
Standard Roll:
50 meters (54.7 linear yards)
Flammability test:
*In accordance with ASTM.
E.84.84
| |
Flame Spread |
Smoke Density |
Fuel Contribution |
| Unpainted (Applied with premixed vinyl adhesive) |
5 |
0 |
0 |
| Painted with latex primer and latex eggshell finish |
10 |
5 |
0 |
Properties:
-
Inherently flame retardant.
-
Dimensionally stable.
-
Mildew resistant.
-
Strengthens wall and
ceiling surfaces.
-
Easy to install.
-
Apply to drywall, plaster,
paneled, concrete and block walls.
-
Made in France.
-
Washable in accordance with
paint used on surface.
|
Application:
"Fibrewall", since it
is strong and stable, will bridge small cracks and joints in most wall
surface. Surface should be clean, dry, and as smooth as
possible. Pourous surfaces such as block wall should be sealed for
best for best results.
Adhesive:
Apply premixed vinly adhesive
directly to wall or ceiling surface with 5/8" or 3/4' paint roller
(200 to 250g/m2 or 250 square feet per gallon).
Installation:
Apply "Fibrewall"
directly to pasted surface making certain seams are tightly jointed (do
not overlap seams). Set seams with soft roller or smoothing brush.
Painting:
Allow "Fibrewall" to
dry for 48 hours before painting. Apply paint with roller, brush or spray
a prime coat and desired finish coat according to paint manufacturers
instructions.
Approximate coverage:
Prime coat 250 square feet per
gallon. Finish coat: 350 to 400 square feet per gallon. |